6% of complaints about the 2001 Jaguar S-Type came in the first year, which is unremarkable for a 2001 vehicle — around the middle of the 216 model-years on record. The median complaint arrives at 7.3 yr in service. The most-reported system is suspension (40 complaints), typically at 8.1 yr or about 73,000 miles.
CERTAIN AFTERMARKET FUEL FILTERS SOLD UNDER THE PUROLATOR BRAND NAME, P/N F65277, SHIPPED FROM JANUARY 16 THROUGH JUNE 2, 2006, FOR USE ON THE ABOVE LISTED PASSENGER VEHICLES. DUE TO INCORRECT DESIGN, THE QUICK CONNECTORS MAY NOT FULLY SEAT WITH THE TUBE INTERFACE, EVEN THOUGH THE PERSON MAKING THE CONNECTION MAY BELIEVE THAT THE QUICK CONNECTOR IS FULLY ATTACHED.
FAILURE OF THIS CONNECTION COULD LEAD TO FUEL SPILLAGE AND, IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
THIS CONDITION MAY CAUSE AN INADEQUATE SEAL AT THE CONNECTION, POTENTIALLY LEADING TO A FUEL LEAK. IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD OCCUR.
VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE FRONT SUSPENSION LOWER BALL JOINTS WERE NOT TIGHTENED TO SPECIFICATIONS WHEN THEY WERE ATTACHED TO THE LOWER CONTROL ARMS.
IF THE BALL JOINT ATTACHING NUTS ARE NOT ADEQUATELY TIGHTENED, THEY CAN LOOSEN AND ULTIMATELY, RESULT IN FRACTURE OF THE BALL JOINT STUD. IF THE BALL JOINT FRACTURES, CONTROL OF THE VEHICLE COULD BE AFFECTED, INCREASING THE RISK OF A CRASH.
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH TRW SEAT BELT BUCKLE ASSEMBLIES. THE BUCKLE BASE OF THESE SEAT BELT ASSEMBLIES WERE NOT PROPERLY HEAT TREATED AND THEREFORE DO NOT PASS THE LOAD BEARING REQUIREMENT OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEAT BELT ASSEMBLIES."
IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
IN 2001, THE YEAR I BOUGHT THE CAR I HAD A CRASH WHERE I LOST THE COMPLETE CONTROL OF THE CAR. I JUST READ THAT THERE WAS A RECALL OF SUSPENSION:FRONT:CONTROL ARM:LOWER BALL JOINT WHICH CAN CAUSE THE CRASH. I AM CERTAIN THAT THIS CAUSED MY CRASH AND DUE THIS I WAS UNDER ENORMOUS TENSION FOR 6 - 8 MONTHS. MY CAR WAS IN BODY SHOP FOR 6 MONTHS WHICH CAUSED ME LOT OF PROBLEMS IN MY DAY TO DAY LIFE. *JB
WHILE STOPPED AT STOP LIGHT, EXPERIENCED CAR ON FIRE. A LADY YELLING FOR ME TO GET OUT, I SAW SMOKE DID NOT KNOW IT WAS MY CAR. *BF THE REAR BACK WHEEL HAD FIRE FLAMING OUT AND HAD GONE OUT BEFORE THE FIRE DEPARTMENT ARRIVED. THE CONSUMER HAD NEW BRAKES PLACED ON THE VEHICLE WHEN IT WAS THREE MONTHS OLD AND HAD RECENTLY PLACED NEW WHEEL BEARINGS ON THE VEHICLE AFTER THE CONSUMER COMPLAINED ABOUT LOAD NOISE. THE CONSUMER REQUESTED INFORMATION ABOUT OTHER SAME MAKE MODELS THAT MAY HAVE THE SAME PROBLEM. *SC
VERY LOUD "CLUNK" NOISE IS HEARD IN THE WHEELS WHEN DRIVING, AND I AM TOLD IT'S THE BALL JOINT/SUSPENSION THAT'S THE CULPRIT. HAVE YET TO HAVE THIS PROBLEM FIXED BUT I UNDERSTAND IT'S A VERY DANGEROUS PROBLEM THAT COULD CAUSE ACCIDENT IF THIS PORTION BREAKS.*AK